This is an old revision of the document!


Pattern Writing

Virtually every videogame involves the manipulation of animated figures. These figures are composed of patterns that are arbitrary pixel arrays. The Bally Arcade's write routines are used to transfer such patterns to the screen.

Five hierarchical levels of write routine calls are supported. The levels differ in the amount of preprocessing required by the user before calling. The highest level assumes that most of the parameters reside in a standard data structure, while the lowest level presumes that all arguments are in registers with all attendant transformations (such as relative-to-absolute conversion) already accomplished. The five levels are:

Level System Routine Function
1 VWRITR Write Relative from a Vector
2 WRITR Write Relative
3 WRITP Write with Size from Pattern Block
4 WRIT Write Pattern
5 WRITA Write Pattern to Absolute (i.e., Screen RAM) Address

Pattern Transformations

Two pattern transformations may be performed prior to writing: FLOP and EXPAND. FLOP mirrors the pattern on the x-axis. EXPAND translates a 1-bit per pixel pattern into a 2-bit per pixel pattern. Since many patterns are only two-color, this allows for more efficient pattern storage. FLOP and EXPAND may be used simultaneously.

Writing Modes

Three Writing Modes may be used: PLOP, OR, and XOR. PLOP is a conventional store into RAM. The OR option ORs the data bit-by-bit with the data that was already present. Similarly, if XOR is set, the pattern is XORed with the data 'beneath' it. Use of OR or XOR takes slightly longer, since a read before write is necessary.

Note that ROTATE is not supported in software due to space considerations.

Standard Calling Sequence

Every write routine uses a subset of the following register/argument assignments:

Register Argument Note
A Magic Register
B Y Pattern Size # Vertical Bytes (i.e., 8 vertical pixels = 8 bytes)
C X Pattern Size # Horizontal Bytes (i.e., 8 horizontal pixels = 1 byte)
D Y-Coordinate 0–101
E X-Coordinate 0–159
HL Pattern Address
IX Vector Address

The Pattern Block

The higher the level of the write routine, the more ancillary information is stored with the pattern. The following diagram shows what each level expects. Any bytes of a lower address than the pointer for a given level need not be specified.

Use Restrictions: None of the write routines are reentrant due to Magic Register / Expander clobber.

X/Y Displacement

This value allows you to set the 'control point' for the pattern. The default point is at the upper lefthand corner of the pattern. Positive x displacements move the control point right, and positive y displacements move the control point down. Moving the control point allows the user to dictate how calculations relate to the pattern. For instance, displacing the control point to the center of a ball pattern can make limit checks consistent from any direction.

X/Y Size

X-size defines the pattern's width in bytes and is dependent upon whether the pattern is full-color or monochrome (expanded). Full-color patterns are stored two-bits-per-pixel (2bpp), so a pattern that is eight pixels wide would have an x-size of two bytes. Monochrome images are stored one-bit-per-pixel (1bpp), so eight pixels would equal one byte.

Y-size defines the pattern's height in bytes.